Timber decks exposed to the elements are at risk from harmful UV rays, which can not only lead to cosmetic problems, such as discoloration and greying, but structural issues as well.

Impact-A’s new Deck Envy rejuvenates, cleans, and restores natural timber. It contains surfactants to remove dirt, oil, grease, algae, and mould while restoring the natural colour to your timber. It is biodegradable and Australian Made, so you know it’s ideal for Aussie conditions.

Deck Envy is also perfect for preparing your deck before applying the topcoat.
It can be used on existing timber to ensure a clean surface before oiling or staining and is ideal for removing naturally occurring tannins in new timber.

Deck Envy is easy to use. Simply mix one-part Deck Envy to four parts water, then using a stiff brush, scrub the mixture into the area to be cleaned. Wait 10 minutes, then hose off. Depending on the stain, you may need to repeat
the process.

• Suitable for exterior use on decking, pergolas, weatherboards, and exposed outdoor timber.
• Not suitable for indoor use.
• Cleans & rejuvenates timber
• Easy to use.
• Removes algae, mould, stains, dirt, oils & grease and restores natural colour of timber.
• Removes naturally occurring tannin from new timber.
• Biodegradable
• Contains Surfactants

CODE: 29166 - 5LTR
Note: – Active ingredient: OXALIC ACID 50 g/L, BENZALKONIUM CHLORIDE 5 g/L

Directions For Use:

CAUTION> Avoid contact with metal surfaces, painted surfaces and vegetation, as it may be corrosive to metals. Rinse off immediately and clean thoroughly if contact occurs.
• Step 1. Prior to using Impact-A Deck Envy, sweep away any loose dirt or debris from deck area you wish to clean. For best results, dampen deck with water before applying product.
• Step 2. Always spot test product in an area that is not critical to the eye, before applying to rest of the deck.
• Step 3. Add one part of Impact-A Deck Envy to four parts water. If you wish to strengthen to mixture, use more Deck Envy solution.
• Step 4. Using a stiff brush, scrub mixture into the area that needs cleaning. Leave for approximately 10 minutes, ensuring mixture doesn’t dry. Sprinkle more water on the area if required to keep it wet.
• Step 5. Rinse cleaned area off with a hose. If you still have stubborn stains left, repeat step 3, and rinse off with a higher amount of water pressure.
• Step 6. Before applying your finish coating, sprinkle water onto the deck surface. If the timber absorbs the water, then the timber is ready for coating. If the water beads, then repeat the cleaning process again.