CHEMSET 101 PLUS is a multi-purpose Polyester adhesive for anchoring threaded studs and starter bars in solid and hollow substrates. It is formulated using high performance, marine grade resin, which allows full load capacity in flooded holes to be attained as assessed to ETAG 001-5 Option 7. CHEMSETâ„¢ 101 PLUS is styrene free and VOC compliant. Fast cure and fast dispensing for high productivity. Non-drip formula, ideal for overhead installation. Steel columns and beams, seating, machinery, facade pins, handrails, gates, starter bars, bottom plate fixing.
Features & Benefits:
- Easy dispensing, even in cold weather
- Sag resistant formula for horizontal holes and overhead application
- Tap value to preserve contents between uses.
Key Features:
- Fast Cure
- Solid and hollow Substrates
- Easy dispensing all year round
Specifications:
- Appearance: Part A: Mauve, part B: Green, Mixed: Green / Grey
- Chemical Type: Polyester
- Density: 1.55kg / Litre @ 20ËšC Hardness> Shore D 80
- Heat Distortion Temperature: Approx. 80ËšC
- Compressive Strength (ASTM C579-01): 20 MPaWorking time (min) @ 20ËšC 5 to 10
- Loading Time @ 20ËšC 90 minute s: Min Installation Temp (ËšC) 0Max Installation Temp (ËšC) 43
- Min Service Temp (ËšC) -10Max Service Temp (ËšC) 80
- Substrates: Solid Concrete, Solid Stone (proof loading recommended), Solid Brick, Hollow Concrete Block, Hollow Brick
Trade:
- Concreter
- Building Contractor
- Civil Contractor
- Contractor
Application:
- Concreter: Starter Bars
- Threaded Studs, Starter Bars, Hollow Masonry Sleeves, Remedial Wall Ties
- Starter Bars Steel Fabricator Threaded Studs, Hollow Masonry Sleeves Balustrade
- Contractor Threaded Studs, Hollow Masonry Sleeves Form worker Starter Bars
- Bricklayer Starter Bars, Remedial Wall Ties Fitter Threaded Studs, Hollow Masonry Sleeves Seating
- Threaded Studs Facade Contractor
- Threaded Studs
Uses:
- Machinery hold down
- Structural steel connections
- Raker angles
- Column hold down
- Seating
- Hand rails
- Fencing
- Balustrade posts
- Starter bars
- Timber and steel house frame bottom plates to comply with BCA and Wind Code
- Close to edge applications
- Safety barriers
Installation in solid:
- Drill hole to specified diameter and depth
- Remove dust and debris by brushing and blowing 3 times each (if hole is wet or flooded, brush only remove water and slurry with wet / dry vacuum)
- Screw mixing nozzle onto cartridge and dispense 2-3 trigger pulls of adhesive to waste until colour is green / grey with no streaks
- Insert tip of Nozzle to bottom of the hole and dispense adhesive
- Fill hole to about 2/3 full
- Insert threaten stud or reinforcing bar with rotating motion to release trapped air
- Wait until adhesive has fully cured before loading
- Clean up with acetone